Load data for 300blk plinking ammo

[Steven]

forming 300 blk casings from 223 brass (for now i’ll only be using LC stamps). i’ll be using a dillon rt1500, with the gsi toolhead and trim dies, on an xl750. i’ll have a separate toolheads for prep/sizing and for loading. these will be plinking rounds.

i just want to verify that i’m going about finding the loading data correctly.

bullets (based off a recommendation on 300blktalk forum):

[https://www.berrysmfg.com/product/bp-30-30-308-150gr-rnfp](https://www.berrysmfg.com/product/bp-30-30-308-150gr-rnfp)

loading data based on my powder (Hodgdon CFE BLK) and bullet info:

[http://www.hodgdonreloading.com/data/rifle?&CartridgeName=300+AAC+Blackout&OrderBW%5B%5D=150&Manufacturer%5B%5D=Hodgdon&Powder%5B%5D=CFE+BLK](http://www.hodgdonreloading.com/data/rifle?&CartridgeName=300+AAC+Blackout&OrderBW%5B%5D=150&Manufacturer%5B%5D=Hodgdon&Powder%5B%5D=CFE+BLK)

​

berry’s recommends a COAL of 2.550″, while hodgdon’s is 2.235″ i’m assuming i go with 2.235″ yes?

i was going to go with 19gr of powder. thoughts?